The PPK-MP28 is a compact threaded pressure sensor offered in analog voltage, current and digital-interface configurations. Select the electrical version first, then choose the pressure range for your measurement task. Each combination is a specific purchase configuration, not a promise that one sensor can switch between every output and range.
The G1/4 threaded connection and compact body support integration into a compatible pressure measurement assembly. Match the mating connection, electrical supply and receiving controller before choosing a version.
Key Features
- Seven electrical options: three analog voltage versions, 4–20 mA, I²C, RS485 and UART.
- Ten selectable pressure ranges, including options with a negative lower limit.
- G1/4 threaded process connection.
- Specified accuracy of ±0.5%FS and operating temperature from −40 to125°C.
Technical Specifications
| Model | PPK-MP28 |
|---|---|
| Accuracy | ±0.5%FS |
| Operating temperature | −40 to125°C |
| Thread | G1/4 |
| Illustrated body dimensions | 37 × 20 mm |
| Supply and output | Version-dependent; see selection guide |
| Selectable pressure ranges | 0–100 kPa; 0–1 MPa; 0–1.6 MPa; 0–3 MPa; 0–3.5 MPa; −100–100 kPa; −100 kPa to 1 MPa; −100 kPa to 1.6 MPa; −100 kPa to 3 MPa; −100 kPa to 3.5 MPa |
Model Selection Guide
| Version | Supply / Output | Selection guidance |
|---|---|---|
| A | 3.3 V / 0.5–2.5 V | Use with an analog voltage input matching the 0.5–2.5 V signal. |
| B | 5 V / 0.5–4.5 V | Use with an analog voltage input matching the 0.5–4.5 V signal. |
| C | 3.3 V / I²C | Choose for an I²C controller interface. |
| D | 12–24 V / 0–10 V | Choose for a controller accepting a 0–10 V signal. |
| E | 12–24 V / 4–20 mA | Choose for a controller accepting a 4–20 mA signal. |
| F | 12–24 V / RS485 | Choose for an RS485 physical interface; match the device protocol before integration. |
| G | 3.3–5 V / UART | Choose for a UART serial interface. |
Applications
- Controller-based pressure measurement systems using a compatible process connection and receiving interface.
Compatibility & Important Notes
- Do not apply a 12–24 V supply to a 3.3 V or 5 V version. Match the exact selected supply and output to your controller.
- Range options containing a negative lower limit are separate versions. Select the required lower and upper limits; do not assume every sensor supports vacuum measurement.
- FS means full scale. Choose a range appropriate to the expected measurement span rather than treating full-scale accuracy as a percentage of every reading.
- RS485 specifies the electrical interface; it does not by itself establish Modbus support. This page does not promise an undocumented baud rate, register map or communication protocol.
- Verify the electrical pin assignments, mating thread and measured-medium compatibility for your installation before applying power or pressure.








Valoraciones
Aún no hay reseñas