---
title: Mini Macro Laser Distance Meter
description: "**1 Project Introduction** ![Mini Macro Laser Distance Meter](https://plugplaykit.com/wp-content/uploads/2026/05/image-1024x576.jpeg?v=1779444642) **2 Application scenarios** Dimension measurement, position tracking, test purpose. Based on this circuit or related peripheral drivers, various applications can be extended. **3 Hardware specifications** Processor: ESP32C3 (WiFi, Bluetooth) Screen: 0.96 TFT…"
url: "https://plugplaykit.com/es/docs/mini-macro-laser-distance-meter/"
updated: "2026-05-22"
category: consumer electronics
---

# Mini Macro Laser Distance Meter

**1 Project Introduction**

![Mini Macro Laser Distance Meter](https://plugplaykit.com/wp-content/uploads/2026/05/image-1024x576.jpeg?v=1779444642)

**2 Application scenarios**

Dimension measurement, position tracking, test purpose.
Based on this circuit or related peripheral drivers, various applications can be extended.

**3 Hardware specifications**

Processor: ESP32C3 (WiFi, Bluetooth)
Screen: 0.96 TFT color display
Operation: Multi-directional reset button
Power supply: Charging and discharging includes lighting (flashlight), soft power on/off
Circuit: buzzer, voltage sampling

![Laser motherboard](https://plugplaykit.com/wp-content/uploads/2026/05/image-1.png?v=1779444004)

**4 Instructions for Use**

Burn the program, use it immediately upon power on, set it to save when powered off, and automatically load the last settings.

When the main control chip is QFN packaged and soldered, please use a heating table → DC low-voltage heating table

Pay attention to distinguishing components with positive and negative poles to avoid short circuits.

Before powering on, please do not necessarily check for a short circuit to avoid chip burnout!!!

Key functions (as shown in the figure below)

![](https://plugplaykit.com/wp-content/uploads/2026/05/image-1024x725.webp)

**5 Program related**

1. Prepare program burning (TTL connection PCB RX TX GND)
2. Press and hold the middle button to insert the USB, select the serial port, and click start (wait for the program to finish burning)

![laser Program related](https://plugplaykit.com/wp-content/uploads/2026/05/image-2.png?v=1779444067)

**PCB**

![laser PCB](https://plugplaykit.com/wp-content/uploads/2026/05/image-3-1024x725.png?v=1779444504)